| CRWL |
INSIDE SURFACE CONDITION |
SMOOTH |
| ABKV |
OUTSIDE DIAMETER |
0.937 INCHES MINIMUM AND 0.999 INCHES MAXIMUM |
| AAGR |
CROSS-SECTIONAL SHAPE STYLE |
ROUND |
| ABJH |
TEMP RATING |
-65.0 DEG FAHRENHEIT SINGLE RESPONSE AND 250.0 DEG FAHRENHEIT SINGLE RESPONSE |
| ADLG |
FIRST END FITTING SPEC/STD DATA |
ARMY ENGINEER RESEARCH AND DEVELOPMENT LABORATORIES 13215E7634-1 STANDARD (INCLUDES INDUSTRY OR ASSOCIATION STANDARDS, INDIVIDUAL MANUFACTUREER STANDARDS, ETC.). |
| CRXX |
MEASURING METHOD AND LENGTH |
30.000 INCHES NOMINAL OVERALL |
| CQBD |
BURST TEST PRESSURE |
14000.0 POUNDS PER SQUARE INCH |
| AWLS |
CONNECTION TYPE |
THREADED INTERNAL TUBE 1ST END |
| CQRB |
SEAT ANGLE |
37.0 DEGREES 1ST END |
| MARK |
SPECIAL MARKINGS |
TWO BAND MARKERS STAMPED W/CIRCUIT NO. 132D |
| CQGH |
FIRST END FITTING/COMPONENT AND MATERIAL |
COMPLETE FITTING STEEL |
| CQBG |
FIRST END SWIVEL ACTION CAPABILITY |
NOT INCLUDED |
| CQGM |
MAXIMUM OPERATING PRESSURE |
3500.0 POUNDS PER SQUARE INCH |
| CRJM |
OUTER COVERING ENVIRONMENTAL PROTECTION |
OIL RESISTANT AND MILDEW RESISTANT AND OIL RESISTANT |
| AAJF |
THREAD DIRECTION |
RIGHT-HAND 1ST END |
| MEDA |
MEDIA FOR WHICH DESIGNED |
FUEL/OIL, HYDROCARBON SINGLE RESPONSE |
| CQCS |
LAYER COMPOSITION AND LOCATION |
2ND LAYER BRAIDED STEEL WIRE ERR-100 |
| THSD |
THREAD SERIES DESIGNATOR |
UNF 1ST END |
| AARX |
INSIDE DIAMETER |
0.485 INCHES MINIMUM AND 0.531 INCHES MAXIMUM |
| CQBB |
SECOND END RELATIONSHIP WITH FIRST END |
IDENTICAL |
| AKUU |
END CONNECTION DESIGN |
STRAIGHT 1ST END |
| CQCS |
LAYER COMPOSITION AND LOCATION |
1ST LAYER BRAIDED STEEL WIRE ERR-100 |
| CRDW |
HYDROSTATIC TEST PRESSURE |
7000.0 POUNDS PER SQUARE INCH |
| ADLF |
HOSE OR TUBING SPEC/STD DATA |
MIL MIL-H-13531,TYPE 2,CLASS A SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL |
| ADJM |
INNER CONVEYING TUBE MATERIAL |
RUBBER, SYNTHETIC |
| CQJX |
NOMINAL THREAD SIZE |
0.750 INCHES 1ST END |
| AAJD |
THREAD CLASS |
2B 1ST END |
| CQCS |
LAYER COMPOSITION AND LOCATION |
OUTER LAYER MOLDED RUBBER, CHLOROPRENE ERR-100 |
| ACKH |
MINIMUM INSIDE BENDING RADIUS |
7.000 INCHES |
| AHNC |
CONNECTION STYLE |
SWIVEL NUT FLARE 1ST END |