| CRWL |
INSIDE SURFACE CONDITION |
SMOOTH |
| AAGR |
CROSS-SECTIONAL SHAPE STYLE |
ROUND |
| AGAV |
END ITEM IDENTIFICATION |
ALLISON GAS TURBINE GENERATOR SET,MDL.501K |
| CQBD |
BURST TEST PRESSURE |
8000.0 POUNDS PER SQUARE INCH |
| AWLS |
CONNECTION TYPE |
THREADED INTERNAL TUBE 1ST END |
| CQGH |
FIRST END FITTING/COMPONENT AND MATERIAL |
COMPLETE FITTING STEEL, QQ-S-763, CLASS 304 |
| CQRB |
SEAT ANGLE |
37.0 DEGREES 1ST END |
| ADLG |
FIRST END FITTING SPEC/STD DATA |
MS27272-6C STANDARD (INCLUDES INDUSTRY OR ASSOCIATION STANDARDS, INDIVIDUAL MANUFACTUREER STANDARDS, ETC.). |
| CRXX |
MEASURING METHOD AND LENGTH |
68.000 INCHES NOMINAL OVERALL |
| CQBG |
FIRST END SWIVEL ACTION CAPABILITY |
NOT INCLUDED |
| ADJM |
INNER CONVEYING TUBE MATERIAL |
PLASTIC, TETRAFLUOROETHYLENE |
| CRJM |
OUTER COVERING ENVIRONMENTAL PROTECTION |
ACID RESISTANT AND SOLVENT RESISTANT AND MILDEW RESISTANT AND FUEL RESISTANT AND OIL RESISTANT AND VIBRATION RESISTANT |
| AAJF |
THREAD DIRECTION |
RIGHT-HAND 1ST END |
| AAJD |
THREAD CLASS |
3B 1ST END |
| CQGM |
MAXIMUM OPERATING PRESSURE |
1500.0 POUNDS PER SQUARE INCH |
| CBBL |
FEATURES PROVIDED |
ELECTROSTATIC DISCHARGE CAPABILITY |
| THSD |
THREAD SERIES DESIGNATOR |
UNF 1ST END |
| CQCS |
LAYER COMPOSITION AND LOCATION |
OUTER LAYER BRAIDED CORROSION RESISTANT STEEL WIRE |
| CQBB |
SECOND END RELATIONSHIP WITH FIRST END |
IDENTICAL |
| AKUU |
END CONNECTION DESIGN |
STRAIGHT 1ST END |
| ACKH |
MINIMUM INSIDE BENDING RADIUS |
4.620 INCHES |
| ABJH |
TEMP RATING |
-65.0 DEG FAHRENHEIT SINGLE RESPONSE AND 450.0 DEG FAHRENHEIT SINGLE RESPONSE |
| CQJX |
NOMINAL THREAD SIZE |
0.750 INCHES 1ST END |
| AARX |
INSIDE DIAMETER |
0.406 INCHES NOMINAL |
| ADLF |
HOSE OR TUBING SPEC/STD DATA |
MIL-H-27267,SIZE 8 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL |
| ABKV |
OUTSIDE DIAMETER |
0.585 INCHES NOMINAL |
| AHNC |
CONNECTION STYLE |
SWIVEL NUT FLARE 1ST END |