| ABHP |
OVERALL LENGTH |
0.645 INCHES MINIMUM AND 0.705 INCHES MAXIMUM |
| ABMK |
OVERALL WIDTH |
0.187 INCHES MINIMUM AND 0.219 INCHES MAXIMUM |
| AAPN |
SECTION QUANTITY |
1 |
| AEHT |
CENTER TO CENTER DISTANCE BETWEEN TERMINALS |
0.090 INCHES MINIMUM AND 0.110 INCHES MAXIMUM |
| ADAU |
BODY HEIGHT |
0.360 INCHES MINIMUM AND 0.390 INCHES MAXIMUM |
| ABTB |
MOUNTING HOLE DIAMETER |
0.069 INCHES MINIMUM AND 0.079 INCHES MAXIMUM |
| TTQY |
TERMINAL TYPE AND QUANTITY |
3 PIN |
| CQCC |
ELECTRICAL RESISTANCE PER SECTION |
20.000 OHMS SINGLE SECTION |
| ADAT |
BODY WIDTH |
0.187 INCHES MINIMUM AND 0.219 INCHES MAXIMUM |
| ABKW |
OVERALL HEIGHT |
0.360 INCHES MINIMUM AND 0.390 INCHES MAXIMUM |
| CRFJ |
TEMP COEFFICIENT OF RESISTANCE PER SECTION IN PPM PER DEG CELSIUS |
-50.0/+50.0 SINGLE SECTION |
| AARG |
RELIABILITY INDICATOR |
NOT ESTABLISHED |
| CQCM |
CENTER TO CENTER DISTANCE BETWEEN CENTER TERMINAL AND OUTSIDE TERMINAL |
0.090 INCHES MINIMUM AND 0.110 INCHES MAXIMUM |
| AAQL |
BODY STYLE |
RECTANGULAR W/MOUNTING HOLES |
| CRGD |
POWER DISSIPATION RATING PER SECTION IN WATTS |
1.0 FREE AIR SINGLE SECTION |
| CQGN |
AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER |
175.0 SINGLE SECTION |
| AEFD |
ACTUATOR TYPE |
SINGLE SHAFT |
| ABJT |
TERMINAL LENGTH |
0.285 INCHES MINIMUM AND 0.315 INCHES MAXIMUM |
| CQCK |
ROTARY ACTUATOR TRAVEL IN ANGULAR DEG |
9000.0 NOMINAL |
| CRSX |
ACTUATOR TRAVEL CONTROL FEATURE |
CONTINUOUS MOTION |
| CRSS |
RESISTANCE TOLERANCE PER SECTION IN PERCENT |
-5.0/+5.0 SINGLE SECTION |
| CSDH |
AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER |
70.0 SINGLE SECTION |
| AEDX |
SHAFT STYLE |
ROUND, SLOTTED |
| AEFK |
MAXIMUM STARTING TORQUE |
5.00 INCH-OUNCES |
| CSDL |
STANDARD TAPER CURVE PER SECTION |
A SINGLE SECTION |
| ABXF |
SHAFT LENGTH |
0.080 INCHES MINIMUM AND 1.000 INCHES MAXIMUM |
| ADAQ |
BODY LENGTH |
0.360 INCHES MINIMUM AND 0.390 INCHES MAXIMUM |
| AEEZ |
CONTACT ARM ELECTRICAL OFF POSITION |
FULLY CW |
| AKPV |
MOUNTING FACILITY QUANTITY |
1 |
| APXH |
TERMINAL LOCATION |
LOWER ADJACENT SIDE FROM ADJUSTMENT CONTROL |
| ABWV |
SHAFT DIAMETER |
0.030 INCHES MINIMUM AND 0.050 INCHES MAXIMUM |
| AXGY |
MOUNTING METHOD |
UNTHREADED HOLE |
| AGTP |
LATERAL DISTANCE BETWEEN MOUNTING HOLE CENTERS |
0.064 INCHES MINIMUM AND 0.084 INCHES MAXIMUM |